Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Glendale, CA
Chimney repair in Glendale usually means one of two things: a cracked clay-tile liner in a 1920s Spanish Colonial Revival up in the Verdugo foothills, or a 1950s stucco tract fireplace that never had a proper liner to begin with. Decades of Santa Ana-driven temperature swings spall old tile, and the South Coast AQMD no-burn rules mean a routine visit often turns into a conversation about whether a fireplace can legally be used at all. At Mantel Chimney Sweep, we diagnose the actual condition first, then repair it with materials built to last – not a temporary patch. Call (844) 821-5749 for a free estimate on chimney repair, sweeping, or dryer vent work.
Why Glendale Homes Are Different
Glendale’s housing stock spans roughly six decades of very different construction methods, and each era brings its own chimney problems. The 1920s through 1940s Spanish Colonial Revival and Tudor homes in neighborhoods like Rossmoyne, Chevy Chase Canyon, and the Verdugo Woodlands were built with original clay-tile flue liners. Those liners are now 80 to 100 years old, and many have spalled – the inner surface flakes away in layers after repeated heating and cooling cycles. Once a clay tile cracks or spalls, it no longer contains heat and combustion gases the way it should.
The Santa Ana winds that push through the San Gabriel Valley foothills do more than scatter leaves. They drive debris and embers into chimney caps, and during fire season ember intrusion into an uncapped or poorly capped flue is a genuine fire risk. Glendale’s mild Mediterranean climate also means fireplaces sit idle for months at a stretch. Soot hardens inside the flue, and birds and squirrels often build nests in that quiet season. When a homeowner lights the first fire of autumn, that accumulated creosote or nesting material is exactly what ignites. We see it every year – and it’s preventable with a pre-season inspection and sweep.
Styles & brands we work with
Our Main Glendale Services
Most Glendale homeowners call us for one of two reasons: a fireplace that needs cleaning and inspection, or a dryer vent that has never been cleared since the house was built. Both are fire-safety issues, and both are services we handle in-house.
Chimney Sweep in Glendale
A sweep in Glendale is rarely just a sweep. Older homes with original clay-tile liners need an inspection that looks for spalling and cracking, not just creosote buildup. Homes in 1950s stucco tracts may have fireplaces that were never fitted with a modern liner at all. We clean thoroughly, then tell you plainly what we found and whether the fireplace is safe to use. The Santa Ana season is a real factor here – a chimney full of debris and an October wind event is a bad combination. Chimney Sweep in Glendale covers everything from routine cleanings to pre-season inspections.
Dryer Vent Cleaning in Glendale
Older Glendale homes often route dryer exhaust through long, convoluted vent runs – some snake through crawl spaces or across flat roofs on mid-century additions. Lint accumulates at every bend, and a clogged dryer vent is one of the leading causes of residential fires in the U.S. In Glendale’s dense 1960s-80s stucco apartment and condo complexes, shared venting and long runs make the problem even more common. Dryer Vent Cleaning in Glendale clears the entire run, checks for damaged ductwork, and confirms proper termination to the exterior.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Glendale
Glendale’s older homes – particularly the Spanish Colonial Revival and Tudor houses built between the 1920s and 1940s – often have original clay-tile chimney liners that have cracked or spalled after decades of heating cycles and Santa Ana temperature swings. That damage is not cosmetic; a compromised liner allows heat and combustion gases to reach combustible framing. Mantel Chimney Sweep repairs what we find using professional materials like HeatShield cerfractory sealant and DuraFlex stainless steel liner systems, so you are not stuck with a report telling you there is a problem and no one to fix it. Our Chimney Repair work covers everything from caps to full relines.
Chimney Liner Installation
Signs you need it
Crumbling clay-tile fragments accumulating in the firebox, visible cracks during a camera inspection, or a strong smoky odor even when the damper is open.
What it costs in Glendale
Full stainless steel liner installations in Glendale typically run $2,500 to $6,500 depending on flue height, accessibility, and the liner system required.
How we do it
We run a camera through the existing flue to confirm dimensions and condition, remove the damaged tile or old liner, then install a properly sized DuraFlex stainless steel liner system with insulation where the clearance requires it.
Chimney Crown Repair
Signs you need it
Cracks or spalling in the concrete crown at the top of the chimney, visible water staining inside the firebox, or efflorescence on the exterior masonry below the crown line.
What it costs in Glendale
Crown repair or resealing in Glendale typically falls between $350 and $1,200 depending on the extent of cracking and whether spot patching or full crown rebuilding is needed.
How we do it
We remove the cracked or deteriorated crown material, form and pour a new properly sloped crown with a drip edge, and seal it so water sheds away from the flue instead of pooling against the masonry.
Chimney Cap Installation
Signs you need it
Debris, leaves, or bird nesting material found in the firebox, water intrusion during rain, or evidence of ember entry around the flue opening during wind events.
What it costs in Glendale
Cap installation in Glendale generally runs $150 to $450 for a standard stainless steel or copper cap sized to your flue, with custom caps for unusual flue shapes running higher.
How we do it
We measure the exact flue dimensions, select a cap rated for your appliance type, and mechanically fasten it so strong Santa Ana gusts cannot dislodge it while still allowing proper drafting.
Chimney Flashing Repair
Signs you need it
Water staining on the ceiling adjacent to the chimney, rusted or lifting flashing at the roofline, or visible gaps where the flashing meets the masonry.
What it costs in Glendale
Flashing repair in Glendale typically ranges from $250 to $800, depending on whether we are resealing existing flashing or cutting in and replacing sections at the roofline.
How we do it
We inspect the flashing-to-masonry interface, remove failed sealant, install new step or counter flashing where needed, and seal the joint so water moves down the roof rather than into the chase.
What Chimney Repair Costs in Glendale
| Item | Typical range in Glendale |
|---|---|
| Chimney cap installation | $150 – $450 |
| Chimney cap replacement | $200 – $500 |
| Chimney liner installation (stainless steel, full system) | $2,500 – $6,500 |
| Chimney flashing repair | $250 – $800 |
| Chimney crown repair | $350 – $1,200 |
Prices in Glendale are shaped by roof access and flue configuration more than anything else. Homes in the Verdugo foothills with steep roof pitches and hard-to-reach chimneys cost more to access, and homes where the flue has multiple bends or a hard offset will push materials and labor up because the liner must be routed through existing offsets precisely.
How long does a chimney liner last in Glendale?
A properly installed stainless steel liner typically lasts 20 to 30 years or more in Glendale’s climate. Original clay tiles in 1920s-40s homes have often failed by now, which is why we recommend a camera inspection any time a home changes hands or before the first burn of the season.
Do I need a permit for chimney repairs in Glendale?
Most minor repairs like cap replacement or crown sealing do not require a permit in Glendale. Full liner installations or structural masonry work may trigger permit requirements through the City of Glendale Building & Safety division. We tell you up front if any repair crosses that threshold, and we can handle the paperwork when needed. Call (844) 821-5749 and we will talk you through it.
Brands We Service in Glendale
The difference between a repair that lasts and one that fails in five years usually comes down to the materials. We work with DuraFlex stainless steel liner systems and HeatShield cerfractory sealant for flue restoration, and we source replacement parts from Famco and Copperfield – names that exist in professional chimney supply chains, not retail shelves. Our brands are chosen because they hold up under Glendale’s heating cycles and Santa Ana conditions.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Glendale, CA
| Service | Typical range in Glendale |
|---|---|
| Chimney sweep (standard, single flue) | $189 – $325 |
| Chimney sweep with camera inspection | $250 – $450 |
| Chimney cap installation | $150 – $450 |
| Chimney cap replacement | $200 – $500 |
| Chimney liner installation (stainless steel, full system) | $2,500 – $6,500 |
| Chimney flashing repair | $250 – $800 |
| Chimney crown repair | $350 – $1,200 |
| Dryer vent cleaning | $125 – $250 |
Two things push prices up in Glendale. The first is roof access – steep foothill roofs, two-story chases, and tight property lines in older neighborhoods all add labor time. The second is liner condition. Homes with failed original clay tiles often need a full reline rather than a simple sweep, and that changes the scope entirely. We give you a flat price before work begins, so there are no surprise line items after the fact.
Neighborhoods We Serve in Glendale
Mantel Chimney Sweep works across the full span of Glendale, from the foothill streets above Foothill Boulevard to the stucco tracts south of Glenoaks. We are in these neighborhoods regularly:
- Chevy Chase Canyon
- Rossmoyne
- Verdugo Woodlands
- Adams Hill
- Citrus Grove
Response time across Glendale is typically one to three business days from your call, depending on the season. We recommend scheduling September and October inspections early – that window fills fast.
Service Area – Cities Near Glendale
Beyond Glendale, Mantel Chimney Sweep regularly serves the neighboring communities across the San Gabriel Valley and northeast Los Angeles. If you are in Burbank, CA, La Cañada Flintridge, CA, Echo Park, CA, or Silver Lake, CA, we can bring the same inspection and repair standards to your chimney, liner, or dryer vent.
Serving Glendale, CA — Our Local Coverage Area
We’re based in the Glendale area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Glendale
Most Glendale appointments are scheduled within one to three business days. During the September-October pre-burn rush, lead times stretch closer to a week, so early fall scheduling is the best way to ensure your fireplace is ready before the first cold evening. Call (844) 821-5749 to check current availability.
Some Glendale homeowners associations – particularly in newer gated complexes and condominium buildings around the 91201 and 91226 ZIP codes – have rules about when work can happen and what materials can be used on shared chimneys. We coordinate with your association when needed and use materials that meet or exceed standard code requirements.
We cover all of Glendale, including the 91201, 91222, 91225, and 91226 ZIP codes. That includes the foothill neighborhoods north of the 210, the central historic districts, and the dense multi-family housing areas south of Broadway. If you own a home anywhere in Glendale, we will inspect it.
If you have not had your chimney looked at in a few years – or you have never seen a camera go through the flue – call us at (844) 821-5749. We will give you a clear picture of the condition, a flat quote for any needed work, and no pressure to do anything that can safely wait. From flue to dryer vent, we repair what others can only report.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Glendale Customers Say
"They were the only ones willing to just tell me the price. Everyone else wanted to "come take a look" first, which in my experience means come apply pressure in person."
— Matt Delaney"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
— Diego Delgado"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
— Tyrone Prince