Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Chino
Dryer vent cleaning in Chino runs $149 – $289 for a standard single-story home, and $189 – $349 when the run is long, crushed, or hasn’t been touched in years. We serve every neighborhood in Chino, including the older 91710 tracts and the newer Preserve and College Park communities in 91708, usually within a few days of your call. If your dryer takes two cycles to finish a load or the laundry room feels hot and damp while the machine runs, that’s the vent telling you it’s time. Call (844) 821-5749 and we’ll get it cleared before the next laundry day.
Key Takeaways:
- Chino dryer vent cleaning averages $149 – $289 for most homes; long runs and crushed flex duct push toward $349
- Our crews know the baked-lint problem specific to Pomona Valley heat and the older 91710 housing stock
- We clean, test airflow, re-run rigid duct where needed, and replace corroded caps in one visit
- Every job includes a full-run camera check so you see what we see
Why Mantel Chimney Sweep Is Chino’s Preferred Dryer Vent Cleaning Company
Chino homeowners call us because we treat a dryer vent the way we treat a chimney: as a fire-containment system, not a tube to poke at. Roland Vega built Mantel Chimney Sweep around that standard. A dryer exhaust run carries lint, heat, and moisture out of your house, and when any of those three gets blocked, the failure is rarely quiet. We service Chino’s split housing stock every week: mid-century ranches in 91710 with foil flex duct that was never meant to last this long, and 2000s-era tract homes in 91708 where the vent run snakes through a hot attic and gets ignored until the dryer groans.
What Chino customers tell us matters as much as what we find in the duct. A homeowner off Euclid Avenue in 91710 thought her dryer was dying. It was a 22-foot run of crushed foil flex, packed with lint baked hard as shellac. We re-ran it in rigid pipe, swapped the rusted cap, and her dry time dropped from 90 minutes to just over 40. That’s the kind of fix that builds a local reputation. We don’t ask Chino homeowners to take our word for anything. We show you the camera footage, give you the airflow reading before and after, and quote any replacement work in plain numbers before we touch it.
Our Dryer Vent Cleaning team responds to Chino calls within one to three business days in most weeks. No dispatch fees, no trip charges buried in the quote. The estimate is free, and the price we quote over the phone is the price on the invoice unless we both agree the scope changed after the camera inspection.
Styles & brands we work with
Our Dryer Vent Cleaning Services in Chino
Dryer Vent Cleaning and Full-Run Inspection
We don’t just shove a brush through the first few feet and call it done. On every Chino job, we clean the full run from the dryer connection to the termination cap, then run a camera through the entire duct. That’s how we find the baked-lint problem that defines Pomona Valley vents. In Chino, summer attic temperatures cross 100°F for weeks at a stretch. Lint that would stay soft and clumped near the coast bakes into a brittle, resin-like sheet here, coating the duct walls and narrowing the run long before the outside hood looks blocked. The camera shows you exactly what’s in there before we clean and after.
Rigid Duct Re-Run and Termination Cap Replacement
Older Chino homes, especially the 1950s-70s ranches in 91710, are full of foil flex duct that was installed decades ago and has been crushed, kinked, or sagging ever since. Foil flex has a rough interior that catches lint by design, and once it’s pinched behind the dryer or wedged into a wall cavity, airflow drops fast. We replace it with smooth rigid metal pipe, properly supported and sealed, so lint slides through instead of piling up. We also replace galvanized termination caps that have corroded shut in the heat-and-dust cycle of the Pomona Valley. A flapper that won’t open turns the last few feet of the run into a lint trap.
Dryer Vent Airflow Testing and Lint Removal
Every cleaning ends with an airflow test at the termination point. We measure the velocity before and after, and you get both numbers on the report. That’s how you know the vent isn’t just cleaner, it’s actually moving air the way it should. For Chino’s 91708 homes with long, winding runs through master-planned layouts, this matters more than average. Factory-built homes can have vents that travel twenty feet or more with multiple elbows, taped with cheap foil at the seams and never re-supported. Each elbow is a place lint accumulates where a shop-vac can’t reach. Our equipment gets the whole run, not just the first bend.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Chino
We work on every major dryer make and vent configuration found in Chino homes, but what we install is where we’re picky. When a termination cap or duct section needs replacing, we use stainless components from Famco and Copperfield, the same supply-chain names we trust on chimney work. Galvanized caps fail faster in Chino’s heat-and-dust cycle. Stainless costs a few dollars more and lasts the life of the home. We keep common duct sizes and cap styles stocked on our trucks so most Chino jobs are completed in a single visit without waiting on parts. The right material, installed right: that’s the standard we hold our dryer vent work to, same as our flue and liner work.
See the difference
Before
After
Before
After
Before
AfterCommon Dryer Vent Cleaning Problems We See in Chino Homes
- Baked, glazed lint from Pomona Valley heat. Chino’s summer attic and wall cavities stay hot for months, and lint turns brittle and resin-like instead of staying damp and loose. It coats the duct walls and narrows the run before the exterior hood shows any visible blockage.
- Crushed foil flex behind the dryer in older 91710 ranches. These homes were built in the 1950s-70s, and the dryer vent was often squeezed into a wall cavity during a past remodel. The duct gets pinched, lint throttles airflow, and dry times climb without the homeowner realizing why.
- Corroded galvanized caps and hoods sealing shut. The heat-and-dust cycle of the Pomona Valley is brutal on thin galvanized metal. The flapper sticks or seizes, lint packs the last few feet of the run, and the dryer pushes against a closed door.
- Long, unsupported vent runs in 91708 factory-built homes. Newer Chino homes can have dryer vents that travel twenty-plus feet through attics with cheap foil tape at every seam and no support straps. Lint accumulates at every elbow, and most standard cleaning tools can’t reach past the first two bends.
One Chino job from this year stands out in our crew’s memory. A 1960s ranch off Central Avenue in 91710, dryer in an interior closet, vent run ending under a cracked galvanized cap at the exterior wall. Our tech pulled the aluminum flex and found it crushed behind the unit, lined with baked, glazed lint that had cut airflow to a trickle. We replaced the run with smooth rigid pipe, swapped the rusted cap for a stainless one, and airflow at the termination came back to where the homeowner’s dryer cycle dropped nearly twenty minutes. Then we flagged the brick chimney crown pitting beside it and quoted the crown and reline work before the next fire season. One visit, two fire hazards, one report the homeowner could actually see.
Pricing for Dryer Vent Cleaning in Chino, CA
A standard dryer vent cleaning in Chino runs $149 – $289 for most single-story homes with a straight or gently curved run. Homes with second-floor laundry rooms, long runs through attics, or vents that terminate on a roof typically land between $229 and $349. If the camera inspection reveals crushed foil flex that needs replacement, a rigid duct re-run adds $75 – $150 per section depending on length and access. Corroded termination cap replacement runs $45 – $95 installed, stainless included. Every quote is flat-price and fixed before work begins, and the camera footage supporting any replacement recommendation is yours to keep. Call (844) 821-5749 for an exact quote for your Chino home. Estimates are free.
Common Dryer Vent Cleaning Problems We See in Chino Homes
We work throughout Chino and the surrounding area, and our crews regularly run jobs in Los Serranos, Ontario, Montclair, and Eastvale as well. If you’re just outside the Chino city line, give us a call anyway. We’re usually no more than a day or two out from any of these communities, and the same flat-price quote and camera-backed report apply wherever the address is.
Serving Chino, CA — Our Local Coverage Area
We’re based in the Chino area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Chino
Every 12 months, regardless of dryer location. In Chino’s Pomona Valley heat, garage and attic-adjacent vents bake lint hard and fast, and interior closet installations often hide longer, kinked runs that load up quickly. If you dry four or more loads a week or have pets, push that to every 8 – 10 months. Call (844) 821-5749 to schedule, and we’ll put you on an annual reminder list so you don’t have to track it.
Yes, in most cases. A rusted galvanized hood in a Chino home from the 1960s or 70s is almost always seized or partially blocked at the flapper. Cleaning the duct without freeing the termination cap is half a job. We carry stainless replacements from Famco and Copperfield, and the swap adds $45 – $95 to the cleaning price, fully installed. We’ll show you the corrosion before we quote it.
Yes, though not because the dryers are different. Factory-built homes in 91708 typically have long vent runs through hot attics with multiple elbows and cheap foil seams that sag over time. The failure mode is lint accumulation at every bend, not the crushed-duct problem we see in older 91710 ranches. The fix is the same: full-run camera inspection, thorough cleaning, and replacing any sagging or taped sections with rigid pipe. Count on the higher end of the pricing range, around $229 – $349, for these longer runs.
Yes. The fire risk doesn’t care about the outside temperature. Lint is flammable at any time of year, and a restricted vent raises the temperature inside the duct and behind the dryer every time the machine runs. In Chino’s older homes, the ducts are often already narrowed by years of baked lint, which means less airflow and higher temperatures sooner. The season doesn’t matter. The restriction does. Get it cleaned if it’s been more than a year. Call (844) 821-5749 for a free estimate.
Not directly, but it changes how people think about household fire risks. Chino sits in the South Coast Air Basin, and the AQMD’s mandatory wood-burning curtailments on cold winter nights mean many households burn less in the fireplace. The dryer, though, runs all year regardless of air quality rules. It’s a ventilation appliance that’s always moving hot, lint-laden air through your house. The same professional who maintains your chimney should be checking that vent. We do both, which is why Chino homeowners often book a dryer vent cleaning and a chimney sweep in the same visit.
Written by Roland Vega, Owner at Mantel Chimney Sweep, serving Chino and the surrounding communities with dryer vent cleaning, chimney sweeping, and flue repair.