Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Yucca Valley, CA
Chimney repair in Yucca Valley means dealing with freeze-thaw damage to masonry crowns, wind-blown sand packed into flues, and a lot of older wood stoves tied into chimneys that were never properly lined. We see it constantly across the 92284 and 92286 ZIP codes: cracked crowns, rusted caps, deteriorating mortar joints, and flue liners that should have been replaced a decade ago. If you’re noticing water stains near the fireplace, mortar bits in the firebox, or a draft that doesn’t pull right, call Mantel Chimney Sweep at (844) 821-5749 and we’ll diagnose it properly.
Why Yucca Valley Homes Are Different
Yucca Valley sits at roughly 3,300 feet in the Morongo Basin high desert, and that elevation changes everything about chimney work here. Winter nights routinely drop below freezing, so unlike the low-desert Coachella Valley below, many homes in Yucca Valley actually burn wood. Wood stoves and pellet stoves aren’t decorative here; they’re often the primary heat source. That means real creosote accumulation, not the light soot you’d get from occasional fires. Annual sweeps in Yucca Valley are a genuine safety need, and the condition of the average flue reflects heavy seasonal use.
The housing stock adds another layer. Much of Yucca Valley is mid-century-to-1970s ranch-style and cabin-like single-story homes, plus scattered rural properties on half-acre-plus lots in unincorporated San Bernardino County. We regularly encounter fireplaces and stoves that were installed decades ago, sometimes by the original homeowner, with flue setups that don’t meet current code. Masonry fireplaces share space with freestanding wood stoves and prefab metal chimneys added after the fact. It’s not unusual to find a wood stove vented into an old masonry chimney with no proper liner at all. In Yucca Valley, inspection matters as much as cleaning.
Then there’s the wind. Seasonal high-wind events and steady desert airflow push fine sand and dust into flues, caps, and spark arrestors far faster than anything you’d see in a humid climate. We routinely find caps so packed with grit they barely breathe, and spark arrestors clogged to the point where draft reverses and smoke rolls back into the living room. Freeze-thaw cycles stress masonry crowns and mortar joints through the winter, and the long dry season keeps wildfire-conscious homeowners asking us to verify that screens and arrestors are clear and functional. This isn’t a coastal chimney market. It’s high desert, and the work reflects it.
Styles & brands we work with





Our Main Yucca Valley Services
Most calls in Yucca Valley come down to two things: a chimney that hasn’t been swept through a full burning season, or a dryer vent that’s quietly packing lint behind the wall. Both are fire hazards, and both are worse here because of the dust load.
Chimney Sweep in Yucca Valley
A proper sweep in Yucca Valley isn’t just removing creosote; it’s clearing wind-blown sand and fine desert dust that builds up on top of the creosote and restricts draft. Given how many homes here burn wood as primary heat, we recommend annual sweeps for active fireplaces and stoves, done before the first cold snap and sometimes again mid-season if fires run nightly. We also check caps and spark arrestors during every sweep, because in this climate they clog fast. Full details on what’s included, what it costs, and how we protect your floors and furnishings are on the dedicated Chimney Sweep in Yucca Valley page.

Dryer Vent Cleaning in Yucca Valley
Clogged dryer vents are one of the leading causes of residential fires, and Yucca Valley’s dusty air makes vents load faster than homeowners expect. If clothes are taking two cycles to dry or the dryer is hot to the touch at the end of a cycle, the vent is likely restricted. We clean the full run from dryer to exterior termination, remove packed lint and desert dust, and verify airflow before we leave. See the full scope, pricing, and warning signs on our Dryer Vent Cleaning in Yucca Valley page.

What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Yucca Valley
Chimney repair in Yucca Valley frequently comes down to two things: masonry damage from freeze-thaw cycles and liner problems in older stove installations. The cold winter nights and strong seasonal winds work on crowns, mortar joints, and flashing year after year, while many of the 1970s-era homes here still have original clay tile liners that are cracked or spalled. We’re a full-service Chimney Repair company, not a sweep-only operator, so when we find damage during a sweep we can actually fix it, using materials like DuraFlex stainless liners and HeatShield cerfractory sealant rather than recommending you call someone else.
Chimney Cap Installation
Signs you need it
You’re finding sand, grit, or bird nesting material in the firebox, or you can see the flue opening is uncovered with no rain protection on top.
What it costs in Yucca Valley
A new chimney cap in Yucca Valley typically runs $180 to $450 including the cap itself and installation labor.
How we do it
We measure the flue opening, select a stainless steel cap sized for proper draft, and secure it to the crown so it holds through high-desert wind events.
Chimney Cap Replacement
Signs you need it
An existing cap is rusted through, bent out of shape from wind, or missing mesh panels that should be keeping embers and birds out.
What it costs in Yucca Valley
Replacing a damaged cap in Yucca Valley costs $200 to $500, with the final figure depending on flue size and whether the old cap has rusted onto the crown.
How we do it
We remove the old cap, inspect the flue opening for damage, and install a correct-fit replacement that seals tightly against the crown.
Chimney Liner Installation
Signs you need it
Your chimney has no liner at all, or a camera inspection shows cracked clay tiles, gaps, or deterioration allowing heat and gases to reach combustible framing.
What it costs in Yucca Valley
A full liner installation in Yucca Valley typically runs $2,200 to $5,500 depending on flue length, diameter, and whether it’s a stainless steel or HeatShield system.
How we do it
We run a camera inspection to confirm the condition, then size and install a DuraFlex flexible stainless liner or apply a HeatShield cerfractory system to restore a safe flue path.
Chimney Flashing Repair
Signs you need it
Water stains appear on the ceiling near the fireplace or on the chimney chase inside the house, especially after the winter rain and wind season.
What it costs in Yucca Valley
Flashing repair in Yucca Valley typically runs $300 to $700, depending on how much of the existing flashing is salvageable.
How we do it
We inspect the roof-to-chimney junction, cut out failed flashing, and install new step and counter flashing sealed with high-temperature caulk made for high-desert temperature swings.
Chimney Crown Repair
Signs you need it
The concrete crown on top of the chimney is cracked, spalling, or has visible gaps around the flue tile where water can enter.
What it costs in Yucca Valley
Crown repair in Yucca Valley ranges from $400 to $1,200, with full crown rebuilds at the higher end when the concrete is too deteriorated to patch.
How we do it
We evaluate the crown’s condition, remove loose or damaged material, and rebuild or reseal it with a proper chimney crown mix that sheds water away from the flue rather than toward it.
What Chimney Repair Costs in Yucca Valley
| Item | Typical range in Yucca Valley |
|---|---|
| Chimney cap installation | $180 – $450 |
| Chimney cap replacement | $200 – $500 |
| Chimney liner installation | $2,200 – $5,500 |
| Chimney flashing repair | $300 – $700 |
| Chimney crown repair | $400 – $1,200 |
Costs above are the ranges we most often see in Yucca Valley. What actually moves the number is the condition of what’s already there: a cap that’s rusted onto the crown takes more labor to remove, a liner that’s fully collapsed needs more prep than one with hairline cracks, and flashing that’s been leaking for years may have damaged the surrounding roof sheathing. Every quote is given as a firm price before work starts, so there’s no guesswork when the bill arrives.
Does a cracked flue liner always need to be replaced in Yucca Valley?
Not always. Hairline cracks can sometimes be addressed with a HeatShield cerfractory sealant, which restores the flue surface without a full liner removal. We camera-inspect every liner before recommending replacement, and we’ll show you exactly what the camera sees. If replacement is the right call, a DuraFlex stainless liner gives you a decades-long fix rather than a patch. Call (844) 821-5749 for a free estimate.
How often should I have my chimney repaired in Yucca Valley?
There’s no fixed interval for repair; the high desert dictates its own schedule. We recommend a visual inspection at least once a year, before the burning season, because freeze-thaw cycles and wind-blown grit are always working on crowns, mortar, and caps. Repair when you see cracks or water intrusion, not on a calendar. Call us for a camera-based inspection and we’ll tell you honestly whether work can wait.
Brands We Service in Yucca Valley
We work with DuraFlex stainless steel liner systems, Olympia Chimney caps and accessories, and Famco and Copperfield components. Parts are stocked for the common installations we see in the Morongo Basin, so most cap and crown jobs are completed in a single visit. See our brands for the full range.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Yucca Valley, CA
| Service | Typical range in Yucca Valley |
|---|---|
| Chimney sweep (standard fireplace) | $149 – $229 |
| Chimney sweep with wood stove | $175 – $275 |
| Dryer vent cleaning | $89 – $169 |
| Chimney cap installation | $180 – $450 |
| Chimney cap replacement | $200 – $500 |
| Chimney liner installation | $2,200 – $5,500 |
| Chimney flashing repair | $300 – $700 |
| Chimney crown repair | $400 – $1,200 |
The biggest price drivers in Yucca Valley are access and existing conditions: a steep roof pitch or a chimney that’s hard to reach safely adds labor, and a liner that’s fully collapsed costs more than one with minor cracking. Wind-packed sand and creosote in an unswept flue also means more time on the roof for any repair that follows a sweep. You’ll always get a firm quote before we start, never an open-ended hourly estimate.
Neighborhoods We Serve in Yucca Valley
We work throughout Yucca Valley and the immediate surroundings, including the residential streets off Highway 62, the spreads along Old Woman Springs Road, and the rural parcels near Yucca Mesa and Flamingo Heights.
- Yucca Mesa
- Flamingo Heights
- Western Hills Estates
- Duarte’s Ranch area
- Sky Harbor area
Response time across the basin is typically within one to two business days for non-emergency work. If you smell smoke inside the house or see water staining near the chimney, call us and we’ll prioritize it.
Service Area – Cities Near Yucca Valley
Mantel Chimney Sweep also serves the surrounding Morongo Basin and upper desert communities. We work regularly in Morongo Valley, CA, Desert Edge, CA, Desert Hot Springs, CA, and Garnet, CA, covering the same chimney repair, sweeping, and dryer vent work we do in Yucca Valley.
Serving Yucca Valley, CA — Our Local Coverage Area
We’re based in the Yucca Valley area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Yucca Valley
Most non-emergency repairs are scheduled within one to two business days across the Yucca Valley area. If you have active water intrusion or smoke backing into the house, we prioritize those calls and will get to you as fast as the schedule allows. Call (844) 821-5749 and we’ll give you a realistic window, not a vague promise.
Most repairs and sweeps in unincorporated San Bernardino County don’t require a permit, but liner installations and structural masonry work can trigger permit requirements depending on scope. We’ll tell you if a permit is needed before any work begins, and we can advise on the right path with the county. We don’t cut corners here because it’s your house, not ours at stake.
Yes, and we see a lot of them given how many homes in the 92284 and 92286 ZIP codes were built in the 1960s and 1970s with stoves added after the fact. Many older installs were never properly lined, so we’ll camera-inspect the full flue path and recommend a liner only if we can show you the evidence on the inspection footage.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Yucca Valley Customers Say
"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Rachel Lawson"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
— Gilbert Garcia"They were the only ones willing to just tell me the price. Everyone else wanted to "come take a look" first, which in my experience means come apply pressure in person."
— Matt Delaney